We use the wire drawing machine in the daily time, its maintenance is very necessary, first of all often have to measure the size of its finished product, check the size is not in line with the standard, if the size of the phenomenon of larger, it needs drawing The mold of the machine to check on the wear and tear, if indeed there is wear and tear, then it must be replaced to ensure that the finished product is qualified drawing products. Followed by regular inspection of the drawing gray box, mainly to observe the amount of drawing powder is not sufficient, if there is insufficient phenomenon, the wire will be on the surface of the impact on the quality.
Drawing machine is running normally, the length of the life of the drawing machine, which are not only the quality of the production process and the existence of relations, and daily maintenance are inseparable. As for the drawing machine, the daily maintenance is not to be ignored, the replacement of wearing parts and lubrication are very important, as the drawing machine in the course of the work, there will be the phenomenon of oxide skin off, and off the oxide if Not clean, then directly into the bearings and roller, therefore, the need for more often into the gray position to clean up, to ensure smooth operation of the components. In the whole wire drawing machine, the position occupied by the drawing die is very important, and only use the mold is standard, can process and produce the standard finished product, also need to regularly check the wire diameter wire drawing to ensure processing Of the products are qualified products.